![]() ![]() Step 2: Assigning an IP Address to the Router’s Interface To do this, you can use the Hostname command in your device’s config mode. You can change the name of your router for the first step. Basic Cisco Commandsįollow the steps below to configure Cisco Router. ![]() ![]() In addition, you can use SDM to configure a Router for the first time. However, instead of using an automatic setup wizard, it is more convenient to configure your device with the CLI command prompt. You can also configure your device as a base with this automatic installation. If you are running the Cisco Router for the first time, you will be presented with an automatic setup screen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |